| Parte n. | Fabbricante | Applicazione |
|---|
| MAX337CWI | MaximIC | Dual 8-channel, low-leakage, CMOS analog multiplexer. |
| MAX792MC/D | MaximIC | Microprocessor and non-volatile metory supervisory circuit. Reset threshold 4.37V |
| MXD1013SA020 | MaximIC | 3-in-1 silicon delay line. Output delay 20ns. |
| MAX6322HPUK37B-T | MaximIC | Microprocessor supervisory circuit with manual reset (manual reset input, reset outputs active-high, push/pull and active-low, open-drain).Factory-trimmed reset threshold(typ) 3.700V, reset timeout(min) 20ms |
| MX7524LCSE | MaximIC | CMOS 8-bit buffered multiplying DAC. TTL/CMOS compatible at +5V. Error +-1/8 LSB |
| MAX4158ESA | MaximIC | 350MHz -3bB bandwidth, 2-channel video multiplexer-amplifier. |
| MAX6335US19D2-T | MaximIC | Ultra-low-voltage, low power microprocessor circuit with manual reset (reset output active-high, push/pull . Reset threshold(typ) 1.9V, reset timeout(min) 20ms. |
| MX7543GKN | MaximIC | CMOS serial input 12 bit DAC. Error +1/2 LSB. |
| MAX6378UR34-T | MaximIC | Ultra-low-power voltage detector, 3.4V |
| MAX6316LUK50DZ-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-low,push/pull).Factory-trimmed reset threshold (typ) 5.000V, min reser timeout 1120ms, typ watchdog timeout 25.6sec. |
| MAX792TCSE | MaximIC | Microprocessor and non-volatile metory supervisory circuit. Reset threshold 3.06V |
| MAX3188EUT-T | MaximIC | 1Mbps, 1microA RS-232 transmitter. |
| MAX792LEPE | MaximIC | Microprocessor and non-volatile metory supervisory circuit. Reset threshold 4.62V |
| MX7536TQ | MaximIC | Microprocessor-compatible, 14-bit D/A converter. Accuracy +-1 LSB. |
| MX7541ASD | MaximIC | CMOS 12 bit multiplying D/A converter. Error 1 LSB. |
| MAX6320PUK43CZ-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input, reset output active-low, open-drain).Factory-trimmed reset threshold(typ) 4.300V, reset timeout(min) 140ms, watchdog timeout(typ) 25.6sec |
| MAX6225AESA | MaximIC | Low-noise, precision, +2.5V output voltage reference. Max TEMPCO (ppm/C) 3.0. |
| MX7545KCWP | MaximIC | CMOS 12-bit buffered multiplying DAC. Error +-1 LSB. |
| MAX1633EAI | MaximIC | Multi-output, low-noise power-supply controller for notebook computers. |
| MAX853C/D | MaximIC | Low-noise, regulated, negative charge-pump power supplies for GaAsFET bias. 1mVp-p output voltage ripple. 100kHz charge-pump switching frequency. Logic-level shutdown mode 1microA max over temp. |
| MAX8885EUK25 | MaximIC | 150mA, low-dropout, linear regulator with power-OK output. Preset output voltage 2.50V. |
| MAX537BEPE | MaximIC | Calibrated, quad, 12-bit voltage-output DAC with serial interface. +-5V supply operation. INL (LSB) +-1 |
| MX7578K/D | MaximIC | Calibrated 12-bit A/D converter |
| MX7845BEWG | MaximIC | Complete, 12-bit multiplying DAC. 4-quadrant multiplication. |
| MAX7221C/D | MaximIC | Serially interfaced, 8-digit LED display driver. Slew-rate limited drivers for lower EMI. SPI, QSPI, Microwire serial interface. |
| MAX6319LHUK49C-T | MaximIC | Microprocessor supervisory circuit with manual reset (manual reset input, reset outputs active-low,push/pull and active-high, push/pull).Factory-trimmed reset threshold(typ) 4.900V, reset timeout(min) 140ms |
| MAX516ACWG | MaximIC | Quad comparator with programmable threshold. Error (LSB) +-1 |
| MAX4074BKESA | MaximIC | Micropower, Rail-to-Rail, fixed-gain, single, GainAmp op amp. Inverting gain 50V/V, noninverting gain 51V/V, -3dB BW 82kHZ. |
| MAX6501CMP105-T | MaximIC | Low-cost, +2.7V to +5.5V micropower temperature switch. Output stage open-drain. Standard temperature threshold(C) +105. |
| MAX6336US25D2-T | MaximIC | Ultra-low-voltage, low-power microprocessor circuit with manual reset (reset output active-low, push/pull . Reset threshold(typ) 2.5V, reset timeout(min) 20ms. |
