| Parte n. | Fabbricante | Applicazione |
|---|
| MAX1242BMJA | MaximIC | +2.7V to +5.25V, low-power, 10-bit serial ADCs in SO-8. INL (LSB) +1 |
| MAX414BMJD | MaximIC | Quad, 28MHz, low-noise, low-voltage, precision op amp. |
| MAX6320PUK31DX-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input, reset output active-low, open-drain).Factory-trimmed reset threshold(typ) 3.080V, reset timeout(min) 1.12sec, watchdog timeout(typ) 102ms |
| MAX314CUE | MaximIC | 10Om, quad, SPST, CMOS analog switch |
| MAX200EWP | MaximIC | +5V RS-232 transceiver with 0.1 microF external capacitors |
| MAX705CSA | MaximIC | Low-cost, microprocessor supervisory circuit. Active-low manual reset input. Independent watchdog timer - 1.6s timeout. Precision supply-voltage monitor 4.65V. |
| REF01CP | MaximIC | +10V precisioon voltage reference. Max TEMPCO 65ppm/degC. Initial error +-100mV |
| MAX7404CPA | MaximIC | 8-th-order, lowpass, elliptic, switched-capacitor filter. Filter response elliptic (r=1.5), operating voltage +3V |
| MAX6318LHUK39DY-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset,(watchdog input,reset output active-low,push/pull; active-high,push/pull).Factory-trimmed reset threshold(typ) 3.900V min, reset timeout 1.12sec,typ watchdog timeout 1.6sec |
| MAX631AMJA | MaximIC | CMOS fixed +5V output voltage,adjustable output with 2 resistors step-up switching regulator. 5% output accuracy. |
| MAX6306UK48D4-T | MaximIC | Multiple-input, programmable reset IC (open-drain reset output, factory-set reset threshold on Vcc, 1 additional undervoltage reset input, manual reset input). Factory-trimmed reset thresholds 4.680(min),4.920(max) Nominal timeout period 1120ms. |
| MAX665CWE | MaximIC | 8V CMOS switched-capacitor voltage converter. |
| MAX147BEAP | MaximIC | +2.7 V, low-power, 8-channel, serial 12-bit ADC. INL(LSB) +-1. |
| MAX6317HUK40CX-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-high, push/pull).Factory-trimmed reset threshold (typ) 4.000V, min reset timeout 140ms, typ watchdog timeout 102ms |
| ICM7217BIPI | MaximIC | 4 digit (LED) presettable up/down ciounter |
| MAX811TEUS-T | MaximIC | Microprocessor voltage monitor with manual reset input. Reset threshold voltage 3.08V |
| MAX547ACMH | MaximIC | Octal, 13-bit voltage-output DAC with parallel interface. INL(LSBs) +-2. |
| MAX4224EUT-T | MaximIC | Dual, 600MHz -3dB bandwidth, min gain +2, low-power, current-feetback amplifier with shutdown. |
| MAX3084ESA | MaximIC | Fail-safe, high-speed (10Mbps), slew-rate-limited RS-485/RS-422 transceiver |
| DG305AA | MaximIC | CMOS dual and quad analog switch. |
| MAX981EPA | MaximIC | Ultra-low-power, open-drain, single comparator. Internal precision reference 2%. Internal hysteresis yes. |
| ICL7663ITV | MaximIC | Programmable positive voltage regulator |
| MAX264BCWI | MaximIC | Pin programmable univesal and bandpass filter. Accuracy 2%. |
| MAX6322HPUK28B-T | MaximIC | Microprocessor supervisory circuit with manual reset (manual reset input, reset outputs active-high, push/pull and active-low, open-drain).Factory-trimmed reset threshold(typ) 2.800V, reset timeout(min) 20ms |
| MAX6316MUK38DW-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-low,bidirectional).Factory-trimmed reset threshold (typ) 3.800V, min reset timeout 1120ms, typ watchdog timeout 6.3ms |
| MAX166DCWP | MaximIC | CMOS microprocessor-compatible, 5 microsec, 8-bit ADC. Error +-1 LSB. |
| MAX291C/D | MaximIC | 8th-order, lowpass, switched-capacitor filter. |
| MAX324ESA | MaximIC | Precision, single-supply, SPST analog switch. |
| MAX6318LHUK44BY-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset,(watchdog input,reset output active-low,push/pull; active-high,push/pull).Factory-trimmed reset threshold(typ) 4.390V min, reset timeout 20ms,typ watchdog timeout 1.6sec |
| MAX1705EEE | MaximIC | 1-cell to 3-cell, high-current, low-noise, step-up DC-DC converter with linerar regulator. |
