| Parte n. | Fabbricante | Applicazione |
|---|
| MXD1013UA070 | MaximIC | 3-in-1 silicon delay line. Output delay 70ns. |
| MAX167CCWG | MaximIC | CMOS 12-bit A/D converter with track-and-hold. Error +-1 LSB. |
| MAX4552ESE | MaximIC | +-15kV ESD-protected, quad, low-voltage, SPST analog switches (four NO switches). |
| MAX6313UK30D4-T | MaximIC | Multiple-input, programmable reset IC (push/pull reset output,factory-set reset threshold on Vcc, 1 additional undervoltage reset input,negative/overvoltage reset input).Factory-trimmed reset thresholds 2.925(min) 3.075(max).Nominal timeout period 1120ms. |
| MAX6320PUK33BW-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input, reset output active-low, open-drain).Factory-trimmed reset threshold(typ) 3.300V, reset timeout(min) 20ms, watchdog timeout(typ) 6.3ms |
| MAX706SEPA | MaximIC | Low-cost, microprocessor supervisory circuit. Precison supply-voltage monitor 2.93V. Active-low reset output signal. |
| MAX419ESD | MaximIC | 1.2microA max, quad, single-supply op amp. |
| MAX6577ZUT | MaximIC | Temperature sensor with frequency output |
| OP37GJ | MaximIC | Low-noise precision operational amplifier. 63MHz gain-bandwidth product. 17V/micros slew rate. |
| MAX6807UR26-T | MaximIC | Voltage detector. Reset output active-high, push-pull. Threshold reset 2.6V |
| MAX9040BEUK-T | MaximIC | Micropower, single-supply operation +2.5V to 5.5V, single comparator + precision reference IC. |
| MAX6336US24D3-T | MaximIC | Ultra-low-voltage, low-power microprocessor circuit with manual reset (reset output active-low, push/pull . Reset threshold(typ) 2.4V, reset timeout(min) 100ms. |
| MAX6307UK30D2-T | MaximIC | Multiple-input, programmable reset IC (open-drain reset output,factory-set reset threshold on Vcc,1additional undervoltage reset input,negative/overvoltage reset inp.).Factory-trimmed reset thresholds2.925(min),3.075(max).Nominal timeout period 20ms. |
| MAX4308ESA | MaximIC | Ultra-low-noise op amp. 220MHz -3dB bandwidth(Avcl=+5) . |
| MX7224LN | MaximIC | CMOS 8-bit DAC with output amplifier. Error +1 LSB. |
| ICL7116CJL | MaximIC | 3 1/2 digit A/D converter with display hold |
| MAX3120EUA | MaximIC | Low-profile, 3V, 120microA, IrDA infrared transceiver. |
| MAX6318MHUK35CZ-T | MaximIC | Microprocessor supervisory circuit with watchdog input (watchdog input,reset output active-high,push/pull and active-low, bidirectional).Factory-trimmed reset threshold(typ) 3.500V, reset timeout(min) 140ms, watchdog timeout(typ) 25.6sec |
| MAX892LEUA-T | MaximIC | Current-limited 250mA, high-side P-channel switch with thermal shutdown. On-resistance 0.25omega |
| MAX6318LHUK28CX-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset,(watchdog input,reset output active-low,push/pull; active-high,push/pull).Factory-trimmed reset threshold(typ) 2.800V min, reset timeout 140ms, typ watchdog timeout 102ms |
| MAX5150ACPE | MaximIC | Low-power, dual, 13-bit voltage-output DAC with serial interface. +5V single-supply operation. INL(LSB) +-1/2. |
| MAX388EJN | MaximIC | High-voltage, fault-protected analog multiplexer. 8-channel single-ended. |
| MAX188AEAP | MaximIC | Low-power, 8-channel, serial 12-bit ADC. |
| MX7628TQ | MaximIC | CMOS dual 8 bit buffered multiplying DAC. +12V to 15V single supply operation. Error +-1/2 LSB. |
| MAX6320PUK49BY-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input, reset output active-low, open-drain).Factory-trimmed reset threshold(typ) 4.900V, reset timeout(min) 20ms, watchdog timeout(typ) 1.6sec |
| MAX700C/D | MaximIC | Power-supply monitor with reset. |
| MAX111BC/D | MaximIC | Low-cost, 2-channel, 14-bit serial ADC. |
| MAX6318MHUK37CW-T | MaximIC | Microprocessor supervisory circuit with watchdog input (watchdog input,reset output active-high,push/pull and active-low, bidirectional).Factory-trimmed reset threshold(typ) 3.700V, reset timeout(min) 140ms, watchdog timeout(typ) 6.3ms |
| MAX853ISA | MaximIC | Low-noise, regulated, negative charge-pump power supplies for GaAsFET bias. 1mVp-p output voltage ripple. 100kHz charge-pump switching frequency. Logic-level shutdown mode 1microA max over temp. |
| MAX6318LHUK33DX-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset,(watchdog input,reset output active-low,push/pull; active-high,push/pull).Factory-trimmed reset threshold(typ) 3.300V min, reset timeout 1.12sec, typ watchdog timeout 102ms |
