| Parte n. | Fabbricante | Applicazione |
|---|
| MAX707CSA | MaximIC | Low-cost, microprocessor supervisory circuit. Active-high reset output. Precision supply-voltage monitor 4.65V. |
| IH5040CJE | MaximIC | General-purpose CMOS analog switch. Single pole, single throw (SPST) |
| MAX635ACSA | MaximIC | Preset -5V output or adjuistable output with 2 resistors, CMOS switching regulator. Output accuracy 5%. |
| MAX712C/D | MaximIC | NiCd/NiMH battery fast-charge controller (by detecting zero voltage slope). |
| MAX4508EAE | MaximIC | Fault-protected, high-voltage single 8-to-1 multiplexer. |
| MAX155AMJI | MaximIC | 8-channel ADC with simultaneous T/Hs and reference. Error +-1/2 LSB. |
| MAX3483EEPA | MaximIC | 3.3V-powered, +-15kV ESD-protected, 15Mbps and slew-rate-limited true RS-485/RS-422 transceiver. Guaranteed data rate 0.25Mbps. Supply voltage 3.0V to 3.6V |
| MAX852ESA | MaximIC | Low-noise, regulated, negative charge-pump power supplies for GaAsFET bias. 2mVp-p output voltage ripple. Logic-level shutdown mode 1microA max over temp. |
| MAX188DCWP | MaximIC | Low-power, 8-channel, serial 12-bit ADC. |
| MAX884ESA | MaximIC | 3.3V or adjustable, low-dropout, low current, 200mA linear regulator. 1microA(max) shutdown(OFF) mode. |
| MAX819LCPA | MaximIC | +5V microprocessor supervisory circuit. Reset threshold 4.65V, active-low reset, backup-battery switchover, power-fail comparator, battery freshness seal, manual reset input. |
| MAX631BEPA | MaximIC | CMOS fixed +5V output voltage,adjustable output with 2 resistors step-up switching regulator. 10% output accuracy. |
| MAX250ESD | MaximIC | +5V powered isolated RS-232 driver/receiver. |
| MAX6316LUK26BY-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-low,push/pull).Factory-trimmed reset threshold (typ) 2.630V, min reset timeout 20ms, typ watchdog timeout 1.6sec |
| MAX6359MRUT-T | MaximIC | Dual-voltage microprocessor supervisory circuit with manual reset. Reset threshold 4.38V (Vcc5) and 2.63V (Vcc3). Active-low push-pull reset 5V. Watchdog timer. |
| MAX120CNG | MaximIC | 500ksps, 12-bit ADCs with track/hold and reference, INL (LSBs) +1 |
| MAX367CPN | MaximIC | Signal-line circuit protector. |
| MAX6318LHUK34DY-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset,(watchdog input,reset output active-low,push/pull; active-high,push/pull).Factory-trimmed reset threshold(typ) 3.400V min, reset timeout 1.12sec, typ watchdog timeout 1.6sec |
| MAX6378XR34-T | MaximIC | Ultra-low-power voltage detector, 3.4V |
| MX7847TQ | MaximIC | Complete, dual, 12-bit multiplying DAC. 12-bit parallel interface. Error (LSB) +-1/2 |
| MAX6321HPUK49AZ-T | MaximIC | Microprocessor supervisory circuit with watchdog (watchdog input, reset outputs active-high, push/pull and active-low, open-drain).Factory-trimmed reset threshold(typ) 4.900V, reset timeout(min) 1ms, watchdog timeout(typ) 25.6sec |
| MAX6360LTUT-T | MaximIC | Dual-voltage microprocessor supervisory circuit with manual reset. Reset threshold 4.63V (Vcc5) and 3.08V (Vcc3). Active-low push-pull reset 3V. Watchdog timer. |
| MAX3480ACPI | MaximIC | Complete, isolated, 3.3V RS-485/RS-422 data interface. Data rate 2500 kbps. |
| MAX1293ACEG | MaximIC | 250ksps, +3V, 4-channel single-ended/2channel pseudo-differential, 12-bit ADC with +2.5V reference and parallel interface INL(LSB) +0.5,-0.5 |
| MAX2650EUS-T | MaximIC | DC-tomicrowave, +5V low-noise amplifier. |
| MAX453CSA | MaximIC | CMOS 50MHz video amplifier with an on-board multiplexer offering 2-channels |
| MAX4578CPP | MaximIC | High-voltage, single 8-to-1 cal-multiplexer. |
| MAX708RCUA | MaximIC | Low-cost, microprocessor supervisory circuit. Precison supply-voltage monitor 2.63V. Active-low and active-high reset output signal. |
| MAX6316MUK25BX-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-low,bidirectional).Factory-trimmed reset threshold (typ) 2.500V, min reset timeout 20ms, typ watchdog timeout 102ms |
| MAX4541CSA | MaximIC | Low-voltage, single-supply dual SPST analog switch. |
