| Parte n. | Fabbricante | Applicazione |
|---|
| MXD1013SA050 | MaximIC | 3-in-1 silicon delay line. Output delay 50ns. |
| MAX6361HUT46-T | MaximIC | Low-power microprocessor supervisory circuit with manual reset input. Reset threshold(typ) 4.63V. Active-high push-pull reset. |
| MAX640C/D | MaximIC | 3.3V or adjustable, high-efficiency, current-limiting PFM control scheme, step-down DC-DC converter. |
| MAX6318MHUK45AW-T | MaximIC | Microprocessor supervisory circuit with watchdog input (watchdog input,reset output active-high,push/pull and active-low, bidirectional).Factory-trimmed reset threshold(typ) 4.500V, reset timeout(min) 1ms, watchdog timeout(typ) 6.3ms |
| MAX333ACPP | MaximIC | Precision, quad, SPDT, CMOS analog switch. |
| MAX305CPE | MaximIC | Precision, dual, high-speed analog switch. |
| MAX501BCWG | MaximIC | Voltage-output, 12-bit multiplying DAC. Error(LSBs) +-3/4. |
| MAX4571EAI | MaximIC | Serially controlled, clickless audio/video switch. 2-wire, fast-mode, IIC-compatible. |
| MAX6313UK40D3-T | MaximIC | Multiple-input, programmable reset IC (push/pull reset output,factory-set reset threshold on Vcc, 1 additional undervoltage reset input,negative/overvoltage reset input).Factory-trimmed reset thresholds 3.900(min) 4.100(max).Nominal timeout period 140ms. |
| MAX5251AEAP | MaximIC | +3V, quad, 10-bit, voltage-output DAC with serial interface. INL(LSB) +-1/2. |
| MAX6320PUK34CY-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input, reset output active-low, open-drain).Factory-trimmed reset threshold(typ) 3.400V, reset timeout(min) 140ms, watchdog timeout(typ) 1.6sec |
| MAX6317HUK28AY-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-high, push/pull).Factory-trimmed reset threshold (typ) 2.800V, min reset timeout 1ms, typ watchdog timeout 1.6sec |
| MAX326CSE | MaximIC | Quad, SPTS, ultra-low leakage, CMOS analog switch. |
| MAX4135EWG | MaximIC | 1-input/6-output video distribution amplifier. Fixed gain of 2V/V, 185MHz -3dB bandwidth. |
| MAX240CMH | MaximIC | +5V-powered, multichannel RS-232 driver-receiver. |
| MAX6316MUK49AZ-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-low,bidirectional).Factory-trimmed reset threshold (typ) 4.900V, min reset timeout 1ms, typ watchdog timeout 25.6sec |
| MAX519AESE | MaximIC | 2-wire serial 8-bit dual DAC with Rail-to-Rail outputs. TUE(LSB) 1. |
| MAX853ESA | MaximIC | Low-noise, regulated, negative charge-pump power supplies for GaAsFET bias. 1mVp-p output voltage ripple. 100kHz charge-pump switching frequency. Logic-level shutdown mode 1microA max over temp. |
| MAX6310UK31D3-T | MaximIC | Multiple-input, programmable reset IC(push/pull reset output,factory-set reset threshold on Vcc,1 additional undervoltage reset input,negative overvoltage reset input).Factory-trimmed reset thresholds 3.003(min),3.157(max). Nominal timeout period 140ms. |
| MAX777LESA | MaximIC | Low-voltage input, step-up DC-DC converter |
| MAX628CPA | MaximIC | Dual power MOSFET driver contains one inverting and one non-inverting section. |
| MAX1241ACPA | MaximIC | +2.7V, low-power, 12-bit serial ADCs in 8-pin SO. INL (LSB) +1/2 |
| MAX505AENG | MaximIC | Quad 8-bit DAC with Rail-to-Rail voltage outputs. Double-buffered logic inputs. TUE +-1 LSB. |
| MAX349CPN | MaximIC | Serially controlled, low-voltage, 8-channel multiplexer |
| MAX6316LUK38AW-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-low,push/pull).Factory-trimmed reset threshold (typ) 3.800V, min reset timeout 1ms, typ watchdog timeout 6.3ms |
| MAX274BC/D | MaximIC | 8th-order continuous-time active filter |
| DG528DK | MaximIC | 8-channel latchable multiplexer |
| MAX4690CAE | MaximIC | 1.25om, quad, SPST, CMOS analog switch (two NO switches). |
| MAX6321HPUK33AW-T | MaximIC | Microprocessor supervisory circuit with watchdog (watchdog input, reset outputs active-high, push/pull and active-low, open-drain).Factory-trimmed reset threshold(typ) 3.300V, reset timeout(min) 1ms, watchdog timeout(typ) 6.3ms |
| MAX4375TESD | MaximIC | Low-cost, micropower, high-side current-sense amplifier + comparator + reference IC. Gain +20V/V. |
