| Parte n. | Fabbricante | Applicazione |
|---|
| MAX635BCSA | MaximIC | Preset -5V output or adjuistable output with 2 resistors, CMOS switching regulator. Output accuracy 10%. |
| DG384CJ | MaximIC | General purpose CMOS dual analog switch. |
| MX7541ABQ | MaximIC | CMOS 12 bit multiplying D/A converter. Error 1/2 LSB. |
| MXD1000SE20 | MaximIC | 5-tap silicon delay line |
| MX7824BQ | MaximIC | CMOS, high-speed, 8-bit ADC with multiplex. Error (LSB) +-1 |
| MAX317EPA | MaximIC | Precision, CMOS analog switch |
| MAX3180EEUK-T | MaximIC | +-15kV ESD-protected, 0.5microA,+3V to +5.5V, 1.5Mbps RS-232 receiver. |
| MAX144BCPA | MaximIC | +2.7 V, low-power, 2-channel, 108 ksps, serial 12-bit ADC. INL(LSB) +-1 |
| MAX281BCWE | MaximIC | 5th-order, zero-error, bessel lowpass filter. |
| MAX1093BEEG | MaximIC | 250ksps, +3V, 4-channel single-ended/2-channel pseudo-differential, 10-bit ADCs with +2.5V reference and parallel interface. INL (LSB) 1 |
| MAX7407EPA | MaximIC | 8-th-order, lowpass, elliptic, switched-capacitor filter. Filter response elliptic (r=1.2), operating voltage +3V |
| MAX6307UK44D4-T | MaximIC | Multiple-input, programmable reset IC (open-drain reset output,factory-set reset threshold on Vcc,1additional undervoltage reset input,negative/overvoltage reset inp.).Factory-trimmed reset thresholds4.270(min),4.490(max).Nominal timeout period 1120ms. |
| MAX120ENG | MaximIC | 500ksps, 12-bit ADCs with track/hold and reference, INL (LSBs) +1 |
| MAX3261E/D | MaximIC | Single +5V, fully integrated, 1.25Gbps laser diode driver. |
| MAX6315US49D2-T | MaximIC | Open-drain microprocessor reset circuit. Reset threshold(nom) 4.90V. Reset timeout period(min) 20ms. |
| MAX430EPA | MaximIC | +-15V Chopper-stabilized operational amplifier. |
| ICL7106CQH | MaximIC | 3 1/2 digit a/d converter |
| MAX6318MHUK41CY-T | MaximIC | Microprocessor supervisory circuit with watchdog input (watchdog input,reset output active-high,push/pull and active-low, bidirectional).Factory-trimmed reset threshold(typ) 4.100V, reset timeout(min) 140ms, watchdog timeout(typ) 1.6sec |
| MAX1658ESA | MaximIC | 350mA, 16.5V input, low-dropout linear regulator |
| MAX652C/D | MaximIC | 3V or adjustable, high-efficiency, current-limited control scheme, step-down DC-DC controller. |
| MAX6310UK37D2-T | MaximIC | Multiple-input, programmable reset IC(push/pull reset output,factory-set reset threshold on Vcc,1 additional undervoltage reset input,negative overvoltage reset input).Factory-trimmed reset thresholds 3.608(min),3.793(max). Nominal timeout period 20ms. |
| MAX149BEPP | MaximIC | +2.7V to +5.25V, low-power, 8-channel, serial 10-bit ADC. INL(LSB) +-1. |
| MAX809ZEXR-T | MaximIC | Microprocessor reset circuit. Reset threshold 2.32V. Push-pull active-high reset. 2.5k increments. |
| MAX6319MHUK45C-T | MaximIC | Microprocessor supervisory circuit with manual reset (manual reset input, reset outputs active-high, push/pull and active-low, bidirectional).Factory-trimmed reset threshold(typ) 4.500V, reset timeout(min) 140ms |
| MAX6316MUK39DZ-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-low,bidirectional).Factory-trimmed reset threshold (typ) 3.900V, min reset timeout 1120ms, typ watchdog timeout 25.6sec |
| TSC427CPA | MaximIC | Dual non-inverting power MOSFET driver. |
| MAX4274ADESA | MaximIC | Dual, Rail-to-Rail, GainAmp op amp with precision internal gain-setting resistors. Rf/Rg inverting gain 1, 1+ (Rf/Dg) noninverting gain 2, -3dB BW 590kHz. |
| MAX337CAI | MaximIC | Dual 8-channel, low-leakage, CMOS analog multiplexer. |
| MAX6317HUK37BZ-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-high, push/pull).Factory-trimmed reset threshold (typ) 3.700V, min reset timeout 20ms, typ watchdog timeout 25.6sec |
| MAX4184ESA | MaximIC | =1. |
